New board operates properly. Now my floor gentle functions. . The floor light-weight stopped performing on my ge microwave. The dilemma was the lamp relay on the manage board. I purchased a refurbished command board from vendor volgacom for 38 bucks (incl.
To replace the board, do the next: get rid of the two screws in the vent include that goes all the way throughout the microwave earlier mentioned the door, open the doorway, get rid of the vent go over, remove one screw from the top rated of the display module, slide the exhibit module up and pull forward, mark the orientation of the connectors, pull out the connectors, unscrew the floor cable, take away the command module from the microwave, pull up the sleeve all around the ribbon cable, pull out the ribbon cable, and eliminate the 5 screws holding the board to the command module. Reverse this procedure for setting up the new board. It took me about 15 minutes to exchange the management board. The new board works beautifully, and i am pretty happy.
Pros
- New board works perfectly. Now my surface light works.
Features of GE Part Number WB27X10473 PCB PARTS ASSY
- PRINTED CIRCUIT BOARD (PCB) PARTS ASSEMBLY
- Works with the following models: General Electric JVM1630BB004, General Electric JVM1630BB005
- General Electric JVM1630BB006, General Electric JVM1630CD001, General Electric JVM1630CD002
PRINTED CIRCUIT BOARD (PCB) PARTS ASSEMBLY
Product Info
- ASIN: B004Q41KXW
Conclusion of GE Part Number WB27X10473 PCB PARTS ASSY
The challenge was the lamp relay on the management board. To substitute the board, do the subsequent: get rid of the 2 screws in the vent go over that goes all the way throughout the microwave previously mentioned the doorway, open the doorway, take away the vent deal with, eliminate 1 screw from the top of the display module, slide the screen module up and pull forward, mark the orientation of the connectors, pull out the connectors, unscrew the floor cable, take away the command module from the microwave, pull up the sleeve all over the ribbon cable, pull out the ribbon cable, and take away the 5 screws holding the board to the handle module. It took me about 15 minutes to switch the handle board. Below is the data from my microwave:microwave model: jvm1631bb004control board part number: wb27x10473control board code on sticker: ra-otr7n-01note that the negative relay was for 5a 250v and operates on 24v dc.
No comments:
Post a Comment